 |
150mm Flywheel
Similar to the larger flywheel, this smaller tool sweep head will produce slightly better surface finish on smaller parts that fit within this reduced swing. Tool adjustments in rake and roll and depth of cut (not yaw). 6 inch tool sweep, 8 inch outside diameter.
(Flywheel Image shown in photo on Nanoform 250 Ultra, is the same Flywheel for the Planoform 650 but on horizontal orientation shown in photo below.)
Request Sales Followup |
 |
305mm Flywheel (spare)
Spare head supplied with two tool holders.
Request Sales Followup |
| |
Field Balancer
Balancing unit for use in balancing the tools on the flycutter head. Portable and battery powered for use in measuring unbalance on any rotating machinery.
Request Sales Followup |
 |
Coolant Catch Pan
A shroud is supplied to capture diamond turning chips and coolant that is sprayed from the cutting zone. The shroud has a large opening that will not interfere with machine axis travels.
Request Sales Followup |
 |
On Machine Part Thickness Measurement
A depth gage is supplied with digital readout. The gage is mounted to an air bearing slide that allows measurement of the part thickness anywhere in a zone within +/- 75mm from the centerline of the cutting zone. The readout has programmable display resolution, and the gage has depth resolution of 0.2 micron (0.000008 inch).
Request Sales Followup |
 |
Chiller for Flycutter Spindle
A closed loop, refrigerated chiller is used to stabilize the temperature of the machine and spindle. This is powered separately from the machine, and operates separately from the machine controller. With a capacity of 1400 watts, it is available in multiple voltage and frequency options. One chiller can be used to maintain temperature of up to two Precitech machines.
Request Sales Followup |
 |
Integrated Gage Head
This electronic indicator and amplifier are for use by the operator in measuring fixture alignment, etc. The resolution of the indicator is 0.1 micron (5 micro inches) and is shown on the UPX display screen. The full range is +/- 0.25 mm (0.010 inch). The gage head is provided with a magnetic base for flexibility and the probe tip motion can sense in both up and down directions.
Request Sales Followup |
 |
Observation Camera and LCD monitor
A camera with zoom lens is mounted on a magnetic base for flexible setup. The image is displayed on an independent 15 inch LCD color display monitor and does not interfere with machine setup or operation. The field of view size can be varied by the zoom lens from approximately 2 mm up to 8 mm. The working distance is 90 mm.
Request Sales Followup |
 |
Heat Exchanger inside machine (Requires Chiller Option)
This option mounts a water to air heat exchanger inside the machine enclosure. The coolant from the chiller is circulated through the heat exchanger and the air is circulated using a small fan. In this manner the air inside the machine enclosure can be kept more stable in temperature which improves the machine thermal stability.
Request Sales Followup |
 |
LED Task Lamp
The LED task lamp is used to improve illumination of the working zone without the addition of heat. It comes mounted to the machine enclosure with a gooseneck flexible mount. This allows the light to be oriented as desired by the operator. There is a switch on the head for turning the light off when not needed.
|
 |
Remote Jog Pendant
This remote jog pendant allows the operator to perform some setup functions while away from or not facing the machine controller. E stop, axis selection and axis jog.
Request Sales Followup |
|
